Dell Force10 MXL Blade - Dei Mark

VLAN Stacking | 657
dei mark
Set the DEI value on egress according to the color currently assigned to the packet.
Syntax
dei mark {green | yellow} {0 | 1}
Parameters
Defaults
All the packets on egress are marked with DEI 0.
Command Mode
INTERFACE
Command
History
Usage
Information
You must first enable DEI for this configuration to take effect.
Related
Commands
member
Assign a Stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack
compatible command in its configuration.
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface command.
Parameters
Defaults
Not configured.
Command Mode
conf-if-vl-<vlan-id>-stack
Command
History
Usage
Information
You must enable stackable VLAN (using the vlan-stack compatible command) on the VLAN prior to
adding a member to the VLAN.
0 | 1
Enter the bit value you want to map to a color.
green |
yellow
Choose a color:
• Green: High priority packets that are the least preferred to be dropped.
• Yellow: Lower priority packets that are treated as best-effort.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
dei enable Enables DEI.
interface
Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
Range: 1 to 128
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by
the slot/port information.
• For a 40-Gigabyte Ethernet interface, enter the keyword
fortyGigE followed by the slot/
port information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module