Dell Force10 MXL Blade - Mac Learning-Limit Reset; Show Cam Mac Stack-Unit

342 | Layer 2
www.dell.com | support.dell.com
Usage
Information
This is supported on physical interfaces, static LAGs, and LACP LAGs.
Related
Commands
mac learning-limit reset
Reset the MAC address learning-limit error-disabled state.
Syntax
mac learning-limit reset
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
show cam mac stack-unit
Display the Content Addressable Memory (CAM) size and the portions allocated for MAC addresses
and for MAC ACLs.
Syntax
show cam mac stack-unit unit_number port-set port-pipe count [vlan vlan-id] [interface interface]
Parameters
show mac learning-limit Displays details of the mac learning-limit.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
stack-unit unit_number (REQUIRED) Enter the keyword stack-unit followed by a stack member
number to select the stack unit for which to gather information.
Range: 0 to 5
port-set port-pipe (REQUIRED) Enter the keyword port-set followed by a Port-Pipe number
to select the Port-Pipe for which to gather information.
Range: 0
address mac-addr (OPTIONAL) Enter the keyword address followed by a MAC address in
the nn:nn:nn:nn:nn:nn format to display information on that MAC address.
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC
addresses learned dynamically by the switch.
static (OPTIONAL) Enter the keyword static to display only those MAC address
specifically configured on the switch.