Dell Force10 MXL Blade - Ip Igmp Snooping Querier; Show Ip Igmp Snooping Mrouter

Internet Group Management Protocol (IGMP) | 233
ip igmp snooping querier
Enable IGMP querier processing for the VLAN interface.
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, enter no ip igmp snooping querier
command.
Defaults
Not configured
Command Modes
INTERFACE VLAN — (conf-if-vl-n)
Command
History
Usage
Information
This command enables the IGMP switch to send General Queries periodically. This is useful when
there is no multicast router present in the VLAN because the multicast traffic does not need to be
routed. An IP address must be assigned to the VLAN interface for the switch to act as a querier for this
VLAN.
show ip igmp snooping mrouter
Display multicast router interfaces.
Syntax
show ip igmp snooping mrouter [vlan number]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 13-1. show ip igmp snooping mrouter Command Example
Related
Commands
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
vlan number
Enter the keyword vlan followed by the vlan number.
Range: 1 to 4094
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show ip igmp snooping mrouter
Interface Router Ports
Vlan 2 Te 13/3, Po 1
FTOS#
show ip igmp groups Use this IGMP command to view groups.