Dell Force10 MXL Blade - Protocol Spanning-Tree Rstp

Rapid Spanning Tree Protocol (RSTP) | 523
Command Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Related
Commands
edge-port bpdufilter default
Enable BPDU Filter globally to filter transmission of BPDU on port fast enabled interfaces.
Syntax
edge-port bpdufilter default
To disable global bpdu filter default, use the no edge-port bpdufilter default command.
Defaults
Disabled
Command Modes
CONFIGURATION (conf-rstp)
Command
History
protocol spanning-tree rstp
Enter the RSTP mode to configure RSTP.
Syntax
protocol spanning-tree rstp
To exit the RSTP mode, use the exit command.
Defaults
Not configured
Command Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Example
Figure 28-2. protocol spanning-tree rstp Command Example
Usage
Information
RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use the no
description command from RSTP mode.
Related
Commands
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
max-age Changes the wait time before RSTP transitions to the Forwarding state.
hello-time Changes the time interval between BPDUs.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf)#protocol spanning-tree rstp
FTOS(conf-rstp)##no disable
description Disable RSTP globally on the system.