Dell Force10 MXL Blade - u-Boot; Overview; Commands

u-Boot | 81
5
u-Boot
Overview
All commands in this chapter are in u-Boot mode. These commands are supported on the Dell Force10
MXL 10/40GbE Switch Module platform only.
To access this mode, hit any key when the following line appears on the console during a system boot:
Hit any key to stop autoboot:
You enter u-Boot immediately, as indicated by the BOOT_USER# prompt.
Commands
• boot change
• boot selection
• boot show net config retries
• boot write net config retries
• boot zero
• default gateway
• enable
• help
• ignore enable password
• ignore startup config
• interface management ethernet ip address
• no default-gateway
• no interface management ethernet ip address
• reload
• show boot blc
• show boot selection
• show bootflash
• show bootvar
• show default-gateway
• show interface management Ethernet
• show interface management port config
• syntax help
Note: This chapter describes only a few commands available in uBoot mode.