Dell Force10 MXL Blade - Show Ip Management-Route

IPv4 Routing | 313
Figure 15-14. show ip interface brief Command Example (Partial)
show ip management-route
View the IP addresses assigned to the Management interface.
Syntax
show ip management-route [all | connected | summary | static]
Parameters
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the any configured incoming access list. If none is
configured, the phrase “not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
Split horizon... States whether split horizon for RIP is enabled on the interface.
Poison Reverse... States whether poison for RIP is enabled on the interface
ICMP redirects... States if ICMP redirects are sent.
ICMP unreachables... States if ICMP unreachable messages are sent.
Table 15-8. show ip interface brief Column Headings
Field Description
Interface Displays type of interface and the associated slot and port number.
IP-Address Displays the IP address for the interface, if configured.
Ok? Indicates if the hardware is functioning properly.
Method
Displays
Manual if the configuration is read from the saved configuration.
Status
States whether the interface is enabled (up) or disabled (administratively
down
).
Protocol
States whether IP is enabled (up) or disabled (down) on the interface.
Table 15-7. show ip interface Command Example Items (continued)
Lines Description
FTOS#show ip int brief
Interface IP-Address OK? Method Status Protocol
TenGigabitEthernet 0/1 unassigned NO None up down
TenGigabitEthernet 0/2 unassigned YES None up up
TenGigabitEthernet 0/3 unassigned YES None up up
TenGigabitEthernet 0/4 unassigned NO None up down
TenGigabitEthernet 0/5 unassigned NO None up down
TenGigabitEthernet 0/6 unassigned NO None up down
TenGigabitEthernet 0/7 unassigned NO None up down
TenGigabitEthernet 0/8 unassigned NO None up down
TenGigabitEthernet 0/9 unassigned NO None up down
all (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all
Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes directly
connected to the Management interface.