Dell Force10 MXL Blade - Link Aggregation Control Protocol (LACP); Overview; Commands

Link Aggregation Control Protocol (LACP) | 331
17
Link Aggregation Control Protocol (LACP)
Overview
This chapter contains commands for Dell Force10’s implementation of the link aggregation control
protocol (LACP) for the creation of dynamic link aggregation groups (LAGs — called port-channels
in FTOS parlance). For static LAG commands, refer to the section Port Channel Commands in the
Interfaces chapter), based on the standards specified in the IEEE 802.3 Carrier sense multiple access
with collision detection (CSMA/CD) access method and physical layer specifications.
Commands
Use the following commands for LACP:
• clear lacp counters
• debug lacp
• lacp long-timeout
• lacp port-priority
• lacp system-priority
• port-channel mode
• port-channel-protocol lacp
• show lacp
clear lacp counters
Clear Port Channel counters.
Syntax
clear lacp port-channel-number counters
Parameters
Defaults
Without a Port Channel specified, the command clears all Port Channel counters.
Command Modes
EXEC
EXEC Privilege
Command
History
port-channel-number
Enter a port-channel number:
Range: 1 to 128
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module