Dell Force10 MXL Blade - Ip Igmp Snooping Flood; Ip Igmp Snooping Fast-Leave

Internet Group Management Protocol (IGMP) | 231
Related
Commands
ip igmp snooping fast-leave
Enable IGMP snooping fast leave for this VLAN.
Syntax
ip igmp snooping fast-leave
To disable IGMP snooping fast leave, use the no igmp snooping fast-leave command.
Defaults
Not configured
Command Modes
INTERFACE VLAN — (conf-if-vl-n)
Command
History
Usage
Information
Queriers normally send a certain number of queries when a leave message is received prior to deleting
a group from the membership database. There may be situations in which fast deletion of a group is
required. When you enable IGMP fast leave processing, the switch removes an interface from the
multicast group as soon as it detects an IGMP version 2 leave message on the interface.
ip igmp snooping flood
This command controls the flooding behavior of unregistered multicast data packets.When flooding is
disabled, unregistered multicast data traffic is forwarded to only multicast router ports, both static and
dynamic, in a VLAN. If there is no multicast router port in a VLAN, unregistered multicast data traffic
is dropped.
On the MXL Switch, when you configure no ip igmp snooping flood, the system forwards the frames
on mrouter ports for first 96 IGMP snooping enabled VLANs. For all other VLANs, unregistered
multicast packets are dropped.
Syntax
ip igmp snooping flood
Defaults
Enabled
Command Modes
CONFIGURATION
Command
History
no shutdown Activates an interface.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module