Dell Force10 MXL Blade - Interface Null; Interface Range

Interfaces | 245
The Management port is enabled by default (no shutdown). Use the ip address command to assign an
IP address to the Management port.
Related
Commands
interface null
Configure a Null interface on the switch.
Syntax
interface null number
Parameters
Defaults
Not configured; number = 0
Command Modes
CONFIGURATION
Command
History
Example
Figure 14-10. interface null Command Example
Usage
Information
You cannot delete the Null interface. The only configuration command possible in a Null interface is ip
unreachables.
Related
Commands
interface range
This command permits configuration of a range of interfaces to which subsequent commands are
applied (bulk configuration). Using the interface range command, you can enter identical commands
for a range of interface.
Syntax
interface range interface, interface,...
management route Configure a static route that points to the Management interface or a
forwarding router.
duplex (1000/10000 Interfaces) Configure duplex mode on any physical interfaces where the speed is set
to 1000/10000
number
Enter zero (0) as the Null interface number.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf)#interface null 0
FTOS(conf-if-nu-0)#
interface Configures a physical interface.
interface loopback Configures a Loopback interface.
interface port-channel Configures a port channel.
interface vlan Configures a VLAN.
ip unreachables Enables generation of ICMP unreachable messages.