Dell Force10 MXL Blade - Upgrade System

File Management | 35
Defaults
none
Command Modes
EXEC Privilege
Command
History
Usage
Information
You must reload FTOS after executing this command.
Example
Figure 3-13. upgrade boot Command Example
upgrade system
Upgrade the bootflash image or system image.
Syntax
upgrade system {flash: | ftp: | scp: | tftp: | usbflash: | stack-unit {0-5 | all} {A: | B:}
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#upgrade boot ?
all Upgrade both boot flash image and selector image
bootflash-image Upgrade boot flash image
bootselector-image Upgrade boot selector image
FTOS#
0-5
Enter this keyword to upgrade only the mentioned stack-unit
all
Enter this keyword to upgrade all the member units of the stack
ftp
After entering this keyword you can either follow it with the location of the source file in this
form:
//userid:password@hostip/filepath, or press Enter to launch a prompt sequence.
scp
After entering this keyword you can either follow it with the location of the source file in this
form:
//userid:password@hostip/filepath, or press Enter to launch a prompt sequence.
tftp
After entering this keyword you can either follow it with the location of the source file in this
form:
//hostlocation/filepath, or press Enter to launch a prompt sequence.
flash
After entering this keyword you can either follow it with the location of the source file in this
form:
//filepath, or press Enter to launch a prompt sequence.
usbflash
After entering this keyword you can either follow it with the location of the source file in this
form:
//filepath, or press Enter to launch a prompt sequence..
A
Enter this keyword to upgrade the bootflash partition A
B
Enter this keyword to upgrade the bootflash partition B
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module