Dell Force10 MXL Blade - Show Qos Policy-Map

Quality of Service (QoS) | 481
show qos policy-map
View the QoS policy map information.
Syntax
show qos policy-map {summary [interface] | detail [interface]}
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1
Figure 25-2. show qos policy-map detail (IPv4) Command Example
Example 2
Figure 25-3. show qos policy-map summary (IPv4) Command Example
summary interface To view a policy map interface summary, enter the keyword summary and
optionally one of the following keywords and slot/port or number information:
• For a Forty Gigabit Ethernet interface, enter the keyword
Forty
GigabitEthernet followed by the slot/port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
detail interface
To view a policy map interface in detail, enter the keyword detail and optionally
one of the following keywords and slot/port or number information:
• For a FortyGigabit Ethernet interface, enter the keyword
Forty
GigabitEthernet followed by the slot/port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show qos policy-map detail tengigabitethernet 0/0
Interface TenGigabitEthernet 4/1
Policy-map-input policy
Trust diffserv
Queue# Class-map-name Qos-policy-name
0 - q0
1 CM1 q1
2 CM2 q2
3 CM3 q3
FTOS#
FTOS#show qos policy-map summary
Interface policy-map-input policy-map-output
TenGig 4/1 PM1 -
TenGig 4/2 PM2 PMOut
FTOS#