Dell Force10 MXL Blade - Rate Shape; Service-Class Dynamic Dot1 P

464 | Quality of Service (QoS)
www.dell.com | support.dell.com
Related
Commands
rate shape
Shape the traffic output on the selected interface.
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
Defaults
Granularity for rate is Mbps unless the kbps option is used.
Command Modes
INTERFACE
Command
History
Related
Commands
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or
on all interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes
INTERFACE mode entries.
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p command.
Defaults
All dot1p traffic is mapped to Queue 0 unless you enable the service-class dynamic dot1p command.
Then the default mapping is as follows:
rate-police Police traffic output as part of the designated policy.
kbps
Enter this keyword to specify the rate shape in Kilobits per second (Kbps). On
MXL Switch. make the following value a multiple of 64. The default granularity
is Megabits per second (Mbps).
Range: 0-40000000 (Kbps)
rate
Enter the outgoing rate in multiples of 10 Mbps.
Range: 10 to 10000
burst-KB
(OPTIONAL) Enter a number as the burst size in KB.
Range: 0 to 10000
Default: 50
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
rate-shape Shapes the traffic output as part of the designated policy.
Table 25-1. Default dot1p to Queue Mapping
dot1p Queue ID
00
10
20