Dell Force10 MXL Blade - LLDP-MED Commands

Link Layer Discovery Protocol (LLDP) | 363
LLDP-MED Commands
The LLDP-media endpoint discovery (MED) commands in this section are:
• advertise med guest-voice
• advertise med guest-voice-signaling
• advertise med location-identification
• advertise med power-via-mdi
• advertise med softphone-voice
• advertise med streaming-video
• advertise med video-conferencing
• advertise med video-signaling
• advertise med voice
• advertise med voice-signaling
FTOS LLDP-MED commands are an extension of the set of LLDP TLV advertisement commands.
As defined by ANSI/TIA-1057, LLDP-MED provides organizationally specific type length value
(TLVs), so that endpoint devices and network connectivity devices can advertise their characteristics
and configuration information. The Organizational Unique Identifier (OUI) for the
Telecommunications Industry Association (TIA) is 00-12-BB.
• LLDP-MED Endpoint Device — any device that is on an IEEE 802 LAN network edge, can
communicate using IP, and uses the LLDP-MED framework.
• LLDP-MED Network Connectivity Device — any device that provides access to an IEEE 802
LAN to an LLDP-MED endpoint device, and supports IEEE 802.1AB (LLDP) and TIA-1057
(LLDP-MED). The Dell Force10 system is an LLDP-MED network connectivity device.
With regard to connected endpoint devices, LLDP-MED provides network connectivity devices with
the ability to:
• manage inventory
• manage Power over Ethernet (POE)
• identify physical location
• identify network policy
advertise med guest-voice
Configure the system to advertise a separate limited voice service for a guest user with their own IP
telephony handset or other appliances that support interactive voice services.
Syntax
advertise med guest-voice {vlan-id layer2_priority DSCP_value} | {priority-tagged number}
To return to the default, use the no advertise med guest-voice {vlan-id layer2_priority DSCP_value}
|
{priority-tagged number} command.
Parameters
vlan-id
Enter the VLAN ID.
Range: 1 to 4094
layer2_priority
Enter the Layer 2 priority.
Range: 0 to 7