Dell Force10 MXL Blade - Show Interfaces Status

Interfaces | 267
Related
Commands
show interfaces status
Display a summary of interface information or specify a stack unit and interface to display status
information for that specific interface only.
Syntax
show interfaces [interface | stack-unit unit-number] status
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 14-35. show interfaces status Command Example
Related
Commands
show hardware stack-unit Displays data plane and management plane input/output statistics.
show interfaces Displays information on a specific physical interface or virtual interface.
interface
(OPTIONAL) Enter one of the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed
by the slot/port information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show interface status
Port Description Status Speed Duplex Vlan
Te 0/1 Down Auto Auto --
Te 0/2 Down Auto Auto --
Te 0/3 Down Auto Auto --
Te 0/4 Down Auto Auto --
Te 0/5 Down Auto Auto --
Te 0/6 Down Auto Auto --
Te 0/7 Down Auto Auto --
Te 0/8 Up 10000 Mbit Full --
Te 0/9 Down Auto Auto --
Te 0/10 Down Auto Auto --
Te 0/11 Down Auto Auto --
Te 0/12 Down Auto Auto --
Te 0/13 Down Auto Auto --
Te 0/14 Down Auto Auto --
Te 0/15 Down Auto Auto --
Te 0/16 Up 10000 Mbit Full --
FTOS#
show interfaces Displays information on a specific physical interface or virtual interface.