Dell Force10 MXL Blade - Iscsi Target Port; Show Iscsi

326 | iSCSI Optimization
www.dell.com | support.dell.com
iscsi target port
Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication will
be monitored.
Syntax
iscsi target port tcp-port-1[tcp-port-2...tcp-port-16][address ip-address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi target port command.
Parameters
Defaults
860, 3260.
Command Modes
CONFIGURATION
Command
History
Usage
Information
You can configure up to 16 target TCP ports on the switch in one command or multiple commands.
When you use the no iscsi target port command, and the TCP port to be deleted is one bound to a specific IP
address, the IP address value must be included in the command.
show iscsi
Display the currently configured iSCSI settings.
Syntax
show iscsi
Command Mode
EXEC
EXEC Privilege
Command
History
tcp-port-2...tcp-
port-16
Enter the tcp-port number of the iSCSI target ports.
The
tcp-port-n is the TCP port number or a list of TCP port numbers on which the
iSCSI target listens to requests. Separate port numbers with a comma.
Default: 860, 3260.
ip-address
(OPTIONAL) Enter the ip-address that the iSCSI will monitor.
The ip-address specifies the IP address of the iSCSI target.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module