Dell Force10 MXL Blade - Gvrp Enable; Gvrp Registration

GARP VLAN Registration (GVRP) | 221
gvrp enable
Enable GVRP on physical interfaces and LAGs.
Syntax
gvrp enable
To disable GVRP on the interface, use the no gvrp enable command.
Defaults
Disabled
Command Modes
CONFIGURATION-INTERFACE
Command
History
Related
Commands
gvrp registration
Configure the GVRP register type.
Syntax
gvrp registration {fixed | normal | forbidden}
To return to the default, use the gvrp register normal command.
Parameters
Defaults
Default registration is normal
Command Modes
CONFIGURATION-INTERFACE
Command
History
Usage
Information
The fixed registration prevents an interface, configured via the command line to belong to a VLAN
(static configuration), from being un-configured when it receives a Leave message. Therefore, the
registration mode on that interface is fixed.
The normal registration is the default registration. The port’s membership in the VLANs depends on
GVRP. The interface becomes a member of VLANs after learning about the VLAN through GVRP. If
the VLAN is removed from the port that sends GVRP advertisements to this device, then the port will
stop being a member of the VLAN.
Use forbidden when you do not want the interface to advertise or learn about VLANs through GVRP.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
disable Globally disables the GVRP.
fixed
Enter the keyword fixed followed by the VLAN range in a comma
separated VLAN ID set.
normal Enter the keyword normal followed by the VLAN range in a comma
separated VLAN ID set.
This is the default
forbidden Enter the keyword forbidden followed by the VLAN range in a comma
separated VLAN ID set.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module