Dell Force10 MXL Blade - Show Running-Config Monitor Session

436 | Port Monitoring
www.dell.com | support.dell.com
show running-config monitor session
Display the running configuration of all monitor sessions or a specific session.
Syntax
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use just the show running-config
monitor session
command.
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 22-4. show running-config monitor session Command Example
Usage
Information
The monitoring command is saved in the running configuration at the Monitor Session mode level and
can be restored after a chassis reload.
Related
Commands
session-ID
(OPTIONAL) Enter a session identification number.
Range: 0 to 65535
Version 8.3.16.1 Introduced on M I/O Aggregator
FTOS#show running-config monitor session
!
monitor session 8
source TenGigabitEthernet 10/46 destination TenGigabitEthernet 10/1 direction rx
!
monitor session 11
source TenGigabitEthernet 10/0 destination TenGigabitEthernet 10/47 direction rx
FTOS#show running-config monitor session 11
!
monitor session 11
source TenGigabitEthernet 10/0 destination TenGigabitEthernet 10/47 direction rx
monitor session Creates a session for monitoring.
show monitor session Displays a monitor session.