Dell Force10 MXL Blade - Ip Telnet Source-Interface; Ip Tftp Source-Interface

Control and Monitoring | 51
ip telnet source-interface
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
Syntax
ip telnet source-interface interface
Parameters
Defaults
The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes
CONFIGURATION
Command
History
Related
Commands
ip tftp source-interface
Assign an interface’s IP address in outgoing packets for TFTP traffic.
Syntax
ip tftp source-interface interface
Parameters
Defaults
The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes
CONFIGURATION
Command
History
interface
Enter the following keywords and slot/port or number information:
• For Loopback interfaces, enter the keyword
loopback followed by a number from zero (0)
to 16383.
• For a Port Channel, enter the keyword
port-channel followed by a number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port
information.
• For VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
telnet Telnets to another device.
interface
Enter the following keywords and slot/port or number information:
• For Loopback interfaces, enter the keyword
loopback followed by a number from zero
(0) to 16383.
• For a Port Channel, enter the keyword
port-channel followed by a number:1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/
port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module