Dell Force10 MXL Blade - Page 52

52 | Control and Monitoring
www.dell.com | support.dell.com
line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE
mode, where you can set the access conditions for the designated line.
Syntax
line {console 0 | vty number [end-number]}
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
You cannot delete a terminal connection.
Related
Commands
motd-banner
Enable a Message of the Day (MOTD) banner to appear when you log in to the system.
Syntax
motd-banner
Defaults
Enabled on all lines.
Command Modes
LINE
Command
History
ping
Test connectivity between the system and another device by sending echo requests and waiting for
replies.
Syntax
ping [host | ip-address] [count {number | continuous}] [datagram-size] [timeout] [source (ip
src-ipv4-address) | interface] [tos] [df-bit (y|n)] [validate-reply(y|n)] [pattern pattern]
[sweep-min-size] [sweep-max-size] [sweep-interval] [ointerface (ip src-ipv4-address) | interface]
console 0 Enter the keyword console 0 to configure the console port.
The console option is <0-0>.
vty number Enter the keyword vty followed by a number from 0 to 9 to configure a virtual terminal
line for Telnet sessions.
The system supports 10 Telnet sessions.
end-number
(OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to configure.
You can configure multiple lines at one time.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
access-class Restricts incoming connections to a particular IP address in an IP access control list
(ACL).
password Specifies a password for users on terminal lines.
show memory View current memory usage on the MXL switch.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module