Dell Force10 MXL Blade - Default Logging Monitor; Default Logging Trap

596 | Simple Network Management Protocol (SNMP) and Syslog
www.dell.com | support.dell.com
default logging monitor
Return to the default settings for messages logged to the terminal.
Syntax
default logging monitor
Defaults
level = 7 or debugging
Command Modes
CONFIGURATION
Command
History
Related
Commands
default logging trap
Return to the default settings for logging messages to the Syslog servers.
Syntax
default logging trap
Defaults
level = 6 or informational
Command Modes
CONFIGURATION
Command
History
Related
Commands
logging
Configure an IP address or host name of a Syslog server where logging messages will be sent. Multiple
logging servers of IPv4 can be configured.
Syntax
logging {ipv4-address | hostname}
To disable logging, enter no logging.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
logging monitor Sets the logging monitor parameters.
terminal monitor Sends system messages to the terminal/monitor.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
logging trap Limits the messages logged to the Syslog servers based on severity.
ipv4-address
Enter an IPv4 address (A.B.C.D).
hostname
Enter the name of a host already configured and recognized by the switch.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module