Access Control Lists (ACL) | 91
6
Access Control Lists (ACL)
Overview
The Dell Force10 operating software (FTOS) supports the following types of access control lists
(ACLs), IP prefix lists, and route maps:
• Commands Common to all ACL Types
• Common IP ACL Commands
• Standard IP ACL Commands
• Extended IP ACL Commands
• Common MAC Access List Commands
• Standard MAC ACL Commands
• Extended MAC ACL Commands
• IP Prefix List Commands
• Route Map Commands
Commands Common to all ACL Types
The following commands are available within each ACL mode and do not have mode-specific options.
Some commands may use similar names, but require different options to support the different ACL
types (for example, deny).
• description
• remark
• resequence access-list
• resequence prefix-list ipv4
• show config
Note: For ACL commands used in the Trace function, refer to the Secure DHCP Commands
section in the chapter Security.
To Next Page
Loading...
