Dell Force10 MXL Blade - Vrrp Delay Minimum

672 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
virtual-address
Configure up to 12 IP addresses of virtual routers in the VRRP group. You must set at least one virtual
address for the VRRP group to start sending VRRP packets.
Syntax
virtual-address ip-address1 [... ip-address12]
To delete one or more virtual IP addresses, use the
no virtual-address ip-address1 [... ip-address12]
command.
Parameters
Defaults
Not configured.
Command Modes
VRRP
Command
History
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP address is
configured. When you delete the virtual address, the VRRP group stops sending VRRP packets.
A system message appears after you enter or delete the virtual-address command.
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s virtual address with
the same IP address as the interface’s primary IP address and change the priority of the VRRP group to
255.
You can ping the virtual addresses configured in all VRRP groups.
vrrp delay minimum
Set the delay time for VRRP initialization after an interface comes up.
Syntax
vrrp delay minimum seconds
Parameters
Defaults
0
Command Modes
INTERFACE
Command
History
ip-address1
Enter an IP address of the virtual router in dotted decimal format.
The IP address must be on the same subnet as the interface’s primary IP address.
...
ip-address12
(OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in dotted
decimal format. Separate the IP addresses with a space.
The IP addresses must be on the same subnet as the interface’s primary IP address.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
seconds
Enter the number of seconds for the delay for VRRP initialization after an interface
becomes operational.
Range: 0 to 900 (0 indicates no delay)
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module