Dell Force10 MXL Blade - Page 671

Virtual Router Redundancy Protocol (VRRP) | 671
track
Monitor an interface and lower the priority value of the VRRP group on that interface if it is disabled.
Syntax
track interface [priority-cost cost]
To disable monitoring, use the no track interface command.
Parameters
Defaults
cost = 10
Command Modes
VRRP
Command
History
Usage
Information
If you disable the interface, the cost value is subtracted from the priority value and forces a new
MASTER election if the priority value is lower than the priority value in the BACKUP virtual routers.
Authentication:... States whether authentication is configured for the VRRP group. If it is, the
authentication type and the password are listed.
Tracking states... This line is displayed if the track command is configured on an interface. Below
this line, the following information on the tracked interface is displayed:
•
Dn or Up states whether the interface is down or up.
• the interface type slot/port information
Table 38-2. show vrrp Command Description
interface
Enter the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword
loopback followed by a number from 0
to 16383.
• For Port Channel interface types, enter the keyword
port-channel followed by the
number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
cost
(OPTIONAL) Enter a number as the amount to be subtracted from the priority value.
Range: 1 to 254.
Default: 10.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module