Dell Force10 MXL Blade - Ip Split-Horizon

498 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
Related
Commands
ip split-horizon
Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme
prevents any routes learned over a specific interface to be sent back out that interface.
Syntax
ip split-horizon
To disable split-horizon, enter no ip split-horizon.
Defaults
Enabled
Command Modes
INTERFACE
Command History
Related
Commands
maximum-paths
Set RIP to forward packets over multiple paths.
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths command.
Parameters
Defaults
4
Command Modes
ROUTER RIP
Command
History
Usage
Information
RIP supports a maximum of 16 ECMP paths.
neighbor
Define a neighbor router with which to exchange RIP information.
Syntax
neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
ip rip receive version Sets the RIP version for the interface to receive traffic.
version Sets the RIP version to be used for the switch software.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
ip poison-reverse Sets the prefix for RIP routing updates.
number
Enter the number of paths.
Range: 1 to 16.
The default is 4 paths.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module