Dell Force10 MXL Blade - Stack-Unit Renumber

Stacking Commands | 619
stack-unit renumber
Change the stack member ID of any stack member or a stand-alone switch.
Syntax
stack-unit 0-5 renumber 0-5
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
Usage
Information
You can renumber any switch, including the management unit or a stand-alone unit. You cannot
renumber a unit to a number of an active member in the stack.
When executing this command on the Master, the stack reloads. When the members are renumbered,
only that specific unit resets and comes up with the new unit number.
Example
Figure 33-6. stack-unit renumber Command Example
Related
Commands
0-5
The first instance of this value is the stack member unit identifier, from 0 to 5, of the
switch that you want add to the stack.
The second instance of this value is the desired new unit identifier number.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#stack-unit 0 renumber 2
Renumbering master unit will reload the stack. Proceed to renumber [confirm yes/
no]:
reload Reboots FTOS.
redundancy
disable-auto-reboot
Resets the designated stack member.
show system Displays the current status of all stack members or a specific member.