Dell Force10 MXL Blade - Debug Lacp

332 | Link Aggregation Control Protocol (LACP)
www.dell.com | support.dell.com
Related
Commands
debug lacp
Debug LACP (configuration, events etc.)
Syntax
debug lacp [config | events | pdu [in | out | [interface [in | out]]]]
To disable LACP debugging, use the no debug lacp [config | events | pdu [in | out | [interface [in |
out]]]]
command.
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
lacp long-timeout
Configure a long timeout period (30 seconds) for an LACP session.
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-timeout command.
Defaults
1 second
Command Modes
INTERFACE (conf-if-po-number)
Command
History
show lacp Displays the LACP configuration
config (OPTIONAL) Enter the keyword config to debug the LACP configuration.
events (OPTIONAL) Enter the keyword events to debug LACP event information.
pdu in | out (OPTIONAL) Enter the keyword pdu to debug LACP Protocol Data Unit
information. Optionally, enter an
in or out parameter to:
• Receive enter
in
• Transmit enter out
interface in | out
Enter the following keywords and slot/port or number information:
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
Optionally, enter an
in or out parameter:
• Receive enter
in
• Transmit enter out
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module