EasyManua.ls Logo

Dell Force10 MXL Blade - Show Interfaces Configured

Dell Force10 MXL Blade
732 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Interfaces | 263
Related
Commands
show interfaces configured
Display any interface with a non-default configuration.
Syntax
show interfaces configured
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 14-31. show interfaces configured Command Example
Related
Commands
show interfaces configured Displays any interface with a non-default configuration.
show interfaces stack-unit Displays information on all interfaces on a specific stack unit.
strict-priority unicast Displays information of either rate limiting or rate policing on the interface.
show interfaces switchport Displays Layer 2 information about the interfaces.
show inventory Displays the MXL switch type, components (including media), FTOS
version including hardware identification numbers and configured
protocols.
show ip interface Displays Layer 3 information about the interfaces.
show memory Displays the stack unit(s) status.
show range Displays all interfaces configured using the interface range command.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show interfaces configured
TenGigabitEthernet 13/18 is up, line protocol is up
Hardware is DellForce10Eth, address is 00:01:e8:05:f7:fc
Current address is 00:01:e8:05:f7:fc
Interface index is 474791997
Internet address is 1.1.1.1/24
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex, Master
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interfaces" counters 00:12:42
Queueing strategy: fifo
Input Statistics:
10 packets, 10000 bytes
0 Vlans
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 10 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
1 packets, 64 bytes, 0 underruns
1 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 1 Broadcasts, 0 Unicasts
0 Vlans, 0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:04:59
FTOS#
show interfaces Displays information on a specific physical interface or virtual interface.

Table of Contents

Other manuals for Dell Force10 MXL Blade

Related product manuals