Dell Force10 MXL Blade - Show Debugging; Show Environment

Control and Monitoring | 59
Command
History
Example
Figure 4-11. show cpu-traffic-stats Command Example
Usage
Information
Traffic statistics are sorted on a per-interface basis; the interface receiving the most traffic is displayed
first. All CPU and port information is displayed unless a specific port or CPU is specified. Traffic
information is displayed for router ports only; not for management interfaces. The traffic statistics are
collected only after the debug cpu-traffic-stats command is executed; not from the system bootup.
Related
Commands
show debugging
View a list of all enabled debugging processes.
Syntax
show debugging
Command Mode
EXEC Privilege
Command
History
Example
Figure 4-12. show debugging Command Example
show environment
View system component status (for example, temperature, voltage).
Syntax
show environment [all | stack-unit unit-id]
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show cpu-traffic-stats
Processor : CP
--------------
Received 100% traffic on TenGigabitEthernet 8/2 Total packets:100
LLC:0, SNAP:0, IP:100, ARP:0, other:0
Unicast:100, Multicast:0, Broadcast:0
FTOS#
Note: After debugging is complete, use the no debug cpu-traffic-stats command to shut off
traffic statistics collection.
debug cpu-traffic-stats Enables CPU traffic statistics for debugging.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show debug
Generic IP: (Access List: test)
IP packet debugging is on for (Access List: test)
TenGigabitEthernet 0/16
ICMP packet debugging is on for
TenGigabitEthernet 0/16
OSPF:1
OSPF packet debugging is on
DHCP:
DHCP debugging is on
FTOS#