Dell Force10 MXL Blade - Lacp Port-Priority; Lacp System-Priority; Port-Channel Mode

Link Aggregation Control Protocol (LACP) | 333
Usage
Information
This command applies to dynamic port-channel interfaces only. When applied on a static port-channel,
the command has no effect.
Related
Commands
lacp port-priority
Configure the port priority to influence which ports will be put in standby mode when there is a
hardware limitation that prevents all compatible ports from aggregating.
Syntax
lacp port-priority priority-value
To return to the default setting, use the no lacp port-priority priority-value command.
Parameters
Defaults
32768
Command Modes
INTERFACE
Command
History
lacp system-priority
Configure the LACP system priority.
Syntax
lacp system-priority priority-value
Parameters
Defaults
32768
Command Modes
CONFIGURATION
Command
History
port-channel mode
Configure the LACP port channel mode.
Syntax
port-channel number mode [active] [passive] [off]
show lacp Displays the lacp configuration
priority-value
Enter the port-priority value. The higher the value number the lower the priority.
Range: 1 to 65535
Default: 32768
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
priority-value
Enter the system-priority value. The higher the value, the lower the priority.
Range: 1 to 65535
Default: 32768
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module