Dell Force10 MXL Blade - Debug Ip Packet

296 | IPv4 Routing
www.dell.com | support.dell.com
Example
Figure 15-2. debug ip icmp Command Example (Partial)
Usage
Information
Use the count option to stop packets from flooding the user terminal when debugging is turned on.
debug ip packet
View a log of IP packets sent and received.
Syntax
debug ip packet [access-group name] [count value] [interface]
To disable debugging, use the no debug ip packet [access-group name] [count value] [interface]
command.
Parameters
Command Mode
EXEC Privilege
Command
History
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40
access-group name
Enter the keyword access-group followed by the access list name
(maximum 16 characters) to limit the debug output based on the defined rules
in the ACL.
count value (OPTIONAL) Enter the keyword count followed by the count value.
Range: 1 to 65534
Default: Infinity
interface
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For the management interface, enter the keyword
managementethernet followed by the slot/port information. The slot
range is 0 and the port range is 0.
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to
4094.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module