Dell Force10 MXL Blade - Port-Channel Failover-Group

280 | Interfaces
www.dell.com | support.dell.com
Related
Commands
minimum-links
Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for
the LAG to be also in “oper up” status.
Syntax
minimum-links number
Parameters
Defaults
1
Command Modes
INTERFACE
Command
History
Usage
Information
If you use this command to configure the minimum number of links in a LAG that must be in “oper up”
status, the LAG must have at least that number of “oper up” links before it can be declared as up.
For example, if the required minimum is four, and only three are up, then the LAG is considered down.
port-channel failover-group
Access the PORT-CHANNEL FAILOVER-GROUP mode to configure a LAG failover group.
Syntax
port-channel failover-group
To remove all LAG failover groups, use the no port-channel failover-group command.
Defaults
none
Command Modes
CONFIGURATION
Command
History
Usage
Information
This feature groups two LAGs to work in tandem as a supergroup, so that, if one LAG goes down, the
other LAG is taken down automatically, providing an alternate path to reroute traffic, avoiding
oversubscription on the other LAG. You can use both static and dynamic (LACP) LAGs to configure
failover groups. For details, refer to the Port Channel chapter in the FTOS Configuration Guide.
channel-member Adds a physical interface to the LAG.
interface Configures a physical interface.
interface loopback Configures a Loopback interface.
interface null Configures a null interface.
interface vlan Configures a VLAN.
shutdown Disables/Enables the port channel.
number
Enter the number of links in a LAG that must be in “oper up” status.
Range: 1 to 16
Default: 1
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module