Dell Force10 MXL Blade - Logging History; Logging History Size

Simple Network Management Protocol (SNMP) and Syslog | 599
Command
History
Related
Commands
logging history
Specify which messages are logged to the history table of the switch and the SNMP network
management station (if configured).
Syntax
logging history level
To return to the default values, use the no logging history command.
Parameters
Defaults
4 or warnings
Command Modes
CONFIGURATION
Command
History
Usage
Information
When you configure the snmp-server trap-source command, the system messages logged to the history
table are also sent to the SNMP network management station.
Related
Commands
logging history size
Specify the number of messages stored in the FTOS logging history table.
Syntax
logging history size size
To return to the default values, use the no logging history size command.
Parameters
Defaults
1 message
Command Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
logging Enables logging to a Syslog server.
logging on Enables logging.
level
Indicate a value from 0 to 7 or enter one of the following equivalent words:
emergencies, alerts, critical, errors, warnings, notifications, informational, or
debugging.
The default is 4.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
show logging history Displays information logged to the history buffer.
size
Indicate a value as the number of messages to be stored.
Range: 0 to 500.
Default: 1 message.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module