Dell Force10 MXL Blade - Commands

572 | sFlow
www.dell.com | support.dell.com
Commands
The sFlow commands are:
• sflow collector
• sflow enable (Global)
• sflow enable (Interface)
• sflow extended-switch enable
• sflow polling-interval (Global)
• sflow polling-interval (Interface)
• sflow sample-rate (Global)
• sflow sample-rate (Interface)
• show sflow
• show sflow stack-unit
sflow collector
Configure a collector device to which sFlow datagrams are forwarded.
Syntax
sflow collector {ipv4-address} agent-addr {ipv4-address} [number [max-datagram-size
number]] | [max-datagram-size number]
To delete a configured collector, use the no sflow collector {ipv4-address} agent-addr
{ipv4-address} [number [max-datagram-size number]] | [max-datagram-size number] command.
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
You can configure up to two sFlow collectors (IPv4). If two collectors are configured, traffic samples
are sent to both.
The sFlow agent address is carried in a field in SFlow packets and is used by the collector to identify
the sFlow agent.
sflow collector ipv4-address
Enter the IPv4 (A.B.C.D) of the sFlow collector device.
agent-addr ipv4-address
Enter the IPv4 (A.B.C.D) of the sFlow agent in the router.
number
(OPTIONAL) Enter the UDP port number (User Datagram
Protocol).
Range: 0 to 65535
Default: 6343
max-datagram-size number
(OPTIONAL) Enter the keyword max-datagram-size
followed by the size number in bytes.
Range: 400 to 1500
Default: 1400
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module