Dell Force10 MXL Blade - Switchport Mode Private-Vlan

Private VLAN (PVLAN) | 447
switchport mode private-vlan
Set PVLAN mode of the selected port.
Syntax
[no] switchport mode private-vlan {host | promiscuous | trunk}
To remove the PVLAN mode from the selected port, use the no switchport mode private-vlan
command.
Parameters
Defaults
disabled
Command Modes
INTERFACE
Command
History
Usage
Information
The assignment of the various PVLAN port types to port and port channel (LAG) interfaces is
demonstrated below.
Example
Figure 23-11. switchport mode private-vlan Command Example
Related
Commands
host Enter host to configure the selected port or port channel as an isolated interface in a
PVLAN, as described above.
promiscuous Enter promiscuous to configure the selected port or port channel as an promiscuous
interface, as described above.
trunk Enter trunk to configure the selected port or port channel as a trunk port in a PVLAN,
as described above.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#conf
FTOS(conf)#interface TenGigabitEthernet 2/1
FTOS(conf-if-te-2/1)#switchport mode private-vlan promiscuous
FTOS(conf)#interface TenGigabitEthernet 2/2
FTOS(conf-if-te-2/2)#switchport mode private-vlan host
FTOS(conf)#interface TenGigabitEthernet 2/3
FTOS(conf-if-te-2/3)#switchport mode private-vlan trunk
FTOS(conf)#interface port-channel 10
FTOS(conf-if-te-2/3)#switchport mode private-vlan promiscuous
private-vlan mode Sets the mode of the selected VLAN to either community or isolated.
private-vlan mapping
secondary-vlan
Sets the mode of the selected VLAN to primary and then associate
secondary VLANs to it.
show interfaces private-vlan Displays the type and status of PVLAN interfaces.
show vlan private-vlan mapping Display the primary-secondary VLAN mapping.