Dell Force10 MXL Blade - Clear Host; Clear Arp-Cache

292 | IPv4 Routing
www.dell.com | support.dell.com
clear arp-cache
Clear the dynamic ARP entries from a specific interface or optionally delete (no-refresh) ARP entries
from CAM.
Syntax
clear arp-cache [interface | ip ip-address] [no-refresh]
Parameters
Command Modes
EXEC Privilege
Command
History
clear host
Remove one or all dynamically learnt host table entries.
Syntax
clear host name
Parameters
Command Modes
EXEC Privilege
Command
History
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For the Management interface, enter the keyword
ManagementEthernet
followed by the slot/port information. The slot range is 0 and the port range is 0.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
Range: 1 to 128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
ip ip-address
(OPTIONAL) Enter the keyword ip followed by the IP address of the ARP entry
you wish to clear.
no-refresh (OPTIONAL) Enter the keyword no-refresh to delete the ARP entry from CAM.
Or use this option with
interface or ip ip-address to specify which dynamic
ARP entries you want to delete.
Note: Transit traffic may not be forwarded during the period when deleted
ARP entries are resolved again and re-installed in CAM. Use this option with
extreme caution.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
name
Enter the name of the host to delete.
Enter * to delete all host table entries.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module