Dell Force10 MXL Blade - Ip Poison-Reverse

496 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
Related
Commands
distribute-list out
Configure a filter for outgoing routing updates.
Syntax
distribute-list prefix-list-name out [interface | bgp | connected | ospf | static]
To delete the filter, use the no distribute-list prefix-list-name out command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command History
Related
Commands
ip poison-reverse
Set the prefix of the RIP routing updates to the RIP infinity value.
Syntax
ip poison-reverse
To disable poison reverse, use the no ip poison-reverse command.
Defaults
Disabled.
Command Modes
INTERFACE
Command
History
ip prefix-list Enters PREFIX-LIST mode and configures a prefix list.
prefix-list-name
Enter the name of a configured prefix list.
interface
(OPTIONAL) Identifies the interface type slot/port as one of the following:
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
Range: 1 to 128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
connected (OPTIONAL) Enter the keyword connected to filter only directly connected
routes.
ospf (OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
static (OPTIONAL) Enter the keyword static to filter manually configured routes.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
ip prefix-list Enters PREFIX-LIST mode and configures a prefix list.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module