Dell Force10 MXL Blade - Debug Gvrp

GARP VLAN Registration (GVRP) | 219
Related
Commands
debug gvrp
Enable debugging on GVRP.
Syntax
debug gvrp {config | events | pdu}
To disable debugging, use the
no debug gvrp {config | events | pdu} command.
Parameters
Defaults
Disabled
Command Modes
EXEC Privilege
Command
History
disable
Globally disable GVRP.
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults
Enabled
Command Modes
CONFIGURATION-GVRP
Command
History
Related
Commands
show gvrp statistics Displays the GVRP statistics
config Enter the keyword config to enable debugging on the GVRP configuration.
event
Enter the keyword event to enable debugging on the JOIN/LEAVE events.
pdu Enter the keyword pdu followed one of the following Interface keywords and slot/port or
number information:
• For a Port Channel interface, enter the keyword
port-channel followed by a
number: Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
gvrp enable Enables GVRP on physical interfaces and LAGs.
protocol gvrp Accesses the GVRP protocol.