Dell Force10 MXL Blade - Vrrp Delay Reload

Virtual Router Redundancy Protocol (VRRP) | 673
Usage
Information
This command applies to a single interface.When used in conjunction with the vrrp delay reload CLI,
the later timer rules the VRRP enabling. For example, if vrrp delay reload is 600 and the vrrp delay
minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all
interfaces that are up and configured for vrrp.
• When an interface comes up, whether as part of a system reload or an interface reload, the system
waits 300 seconds (5 minutes) to bring up VRRP on that interface.
Related
Commands
vrrp delay reload
Set the delay time for VRRP initialization after a system reboot.
Syntax
vrrp delay minimum seconds
Parameters
Defaults
0
Command Modes
INTERFACE
Command
History
Usage
Information
This command applies to a all the VRRP configured interfaces on a system. When used in conjunction
with the vrrp delay minimum CLI, the later timer rules the VRRP enabling. For example, if vrrp delay
reload is 600 and the vrrp delay minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all
interfaces that are up and configured for vrrp.
• When an interface comes up, whether as part of a system reload or an interface reload, the system
waits 300 seconds (5 minutes) to bring up VRRP on that interface.
You must save the configuration and reload the system for the delay timers to take affect.
Related
Commands
vrrp delay reload Sets the delay time for VRRP initialization after a system reboot.
seconds
Enter the number of seconds for the delay.
Range: 0 to 900 (0 indicates no delay)
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
vrrp delay minimum Sets the delay time for VRRP initialization after a line card reboot.