Dell Force10 MXL Blade - Ip Ospf Transmit-Delay

402 | Open Shortest Path First (OSPFv2)
www.dell.com | support.dell.com
Parameters
Defaults
5 seconds
Command Modes
INTERFACE
Command
History
Usage
Information
Set the time interval to a number large enough to prevent unnecessary retransmissions.
ip ospf transmit-delay
Set the estimated time elapsed to send a link state update packet on the interface.
Syntax
ip ospf transmit-delay seconds
To return to the default value, use the no ip ospf transmit-delay command.
Parameters
Defaults
1 second
Command Modes
INTERFACE
Command
History
log-adjacency-changes
Set FTOS to send a Syslog message about changes in the OSPF adjacency state.
Syntax
log-adjacency-changes
To disable the Syslog messages, use the no log-adjacency-changes command.
Defaults
Disabled.
Command Mode
ROUTER OSPF
Command
History
seconds
Enter the number of seconds as the interval between retransmission.
Range: 1 to 3600.
Default: 5 seconds.
This interval must be greater than the expected round-trip time for a packet to travel
between two routers.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
seconds
Enter the number of seconds as the transmission time. This value should be greater than the
transmission and propagation delays for the interface.
Range: 1 to 3600.
Default: 1 second.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module