Dell Force10 MXL Blade - Terminal Monitor; Show Logging Driverlog Stack-Unit

604 | Simple Network Management Protocol (SNMP) and Syslog
www.dell.com | support.dell.com
Figure 31-14. show logging history Command Example
show logging driverlog stack-unit
Display the driver log for the specified stack member.
Syntax
show logging driverlog stack-unit unit#
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
This command displays internal software driver information, which may be useful during
troubleshooting switch initialization errors, such as a downed Port-Pipe.
terminal monitor
Configure the FTOS to display messages on the monitor/terminal.
Syntax
terminal monitor
To return to default settings, use the terminal no monitor command.
Defaults
Disabled.
Command Modes
EXEC
EXEC Privilege
Command
History
Related
Commands
FTOS#show logging history
Syslog History Table: 1 maximum table entries,
saving level warnings or higher
SNMP notifications not Enabled
May 22 08:53:09: %STKUNIT0-M:CP %SEC-3-AUTHENTICATION_ENABLE_SUCCESS: Enable
password authentication success on vty0 ( 10.11.68.22 )
FTOS#
stack-unit unit# Enter the keyword stack-unit followed by the stack member ID of the switch for
which you want to display the driver log.
Range: 0 to 1
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
logging monitor Sets the logging parameters on the monitor/terminal.