Dell Force10 MXL Blade - Show Startup-Config

32 | File Management
www.dell.com | support.dell.com
Command Modes
EXEC Privilege
Command
History
Example
Figure 3-9. show running-config Command Example (Partial)
Example
Figure 3-10. show running-config Command Example
Usage
Information
The status option allows you to display the size and checksum of the running configuration and the
startup configuration.
show startup-config
Display the startup configuration.
Syntax
show startup-config
Command Modes
EXEC Privilege
Command
History
configured
(OPTIONAL) Enter the keyword configuration to display line card
interfaces with non-default configurations only.
status
(OPTIONAL) Enter the keyword status to display the checksum for the
running configuration and the start-up configuration.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show running-config
Current Configuration ...
! Version E8-3-16-29
! Last configuration change at Thu Apr 26 19:19:21 2012 by admin
! Startup-config last updated at Thu Apr 26 19:19:04 2012 by default
!
boot system stack-unit 0 primary system: A:
boot system stack-unit 0 secondary tftp://10.11.200.241/dt-m1000e-5-c2
boot system gateway 10.11.209.254
!
redundancy auto-synchronize full
redundancy disable-auto-reboot stack-unit
!
redundancy disable-auto-reboot stack-unit 0
redundancy disable-auto-reboot stack-unit 1
redundancy disable-auto-reboot stack-unit 2
redundancy disable-auto-reboot stack-unit 5
!--More--
service timestamps log datetime
logging coredump stack-unit all
!
hostname FTOS
!
...
FTOS#show running-config status
running-config bytes 4306, checksum 0x4D55EE70
startup-config bytes 4344, checksum 0x6472C5E
FTOS#
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module