Dell Force10 MXL Blade - Snmp-Server Group

586 | Simple Network Management Protocol (SNMP) and Syslog
www.dell.com | support.dell.com
Parameters
Defaults
As above
Command Modes
CONFIGURATION
Command
History
Usage
Information
Changing the value of the SNMP Engine ID has important side effects. A user’s password (entered on
the command line) is converted to a message digest 5 algorithm (MD5) or secure hash algorithm
(SHA) security digest. This digest is based on both the password and the local Engine ID. The
command line password is then destroyed, as required by RFC 2274. Because of this deletion, if the
local value of the Engine ID changes, the security digests of SNMPv3 users will be invalid, and the
users will have to be reconfigured.
For the remote Engine ID, the host IP and UDP port are the indexes to the command that are matched
to either overwrite or remove the configuration.
Related
Commands
snmp-server group
Configure a new SNMP group or a table that maps SNMP users to SNMP views.
Syntax
snmp-server group [group_name {1 | 2c | 3 {auth | noauth | priv}}] [read name] [write name]
[notify name] [access-list-name | access-list-name]]
To remove a specified group, use the no snmp-server group [group_name {v1 | v2c | v3 {auth |
noauth | priv}}] [read name] [write name] [notify name] [access-list-name | access-list-name]]
command.
local engineID
Enter the keyword local followed by the engine ID number that identifies
the copy of the SNMP on the local device.
Format (as specified in RFC 3411): 12 octets.
• The first 4 octets are set to the private enterprise number.
• The remaining 8 octets are the MAC address of the chassis.
remote ip-address
Enter the keyword remote followed by the IP address that identifies the
copy of the SNMP on the remote device.
udp-port port-number
engineID
Enter the keyword udp-port followed by the UDP (User Datagram
Protocol) port number on the remote device.
Range: 0 to 65535
Default: 162
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
show snmp engineID
Displays SNMP engine and all remote engines that are configured on the
router.
show running-config snmp Displays the SNMP running configuration.