Dell Force10 MXL Blade - Match Ip Access-Group

470 | Quality of Service (QoS)
www.dell.com | support.dell.com
match ip access-group
Configure match criteria for a class map, based on the access control list (ACL).
Syntax
match ip access-group access-group-name [set-ip-dscp value]
To remove ACL match criteria from a class map, use the no match ip access-group
access-group-name [set-ip-dscp value] command.
Parameters
Defaults
none
Command Modes
CLASS-MAP CONFIGURATION (config-class-map)
Command
History
Usage
Information
You must enter the class-map command in order to access this command. After the class map is
identified, you can configure the match criteria. For class-map match-any, a maximum of five ACL
match criteria are allowed. For class-map match-all, only one ACL match criteria is allowed.
Related
Commands
description
Add a description to the selected policy map or QOS policy.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Defaults
none
Command Modes
CONFIGURATION (policy-map-input and policy-map-output; conf-qos-policy-in and
conf-qos-policy-out; wred)
Command
History
Related
Commands
access-group-name
Enter the ACL name whose contents are used as the match criteria in
determining if packets belong to the class specified by
class-map.
set-ip-dscp value (OPTIONAL) Enter the keyword set-ip-dscp followed by the IP DSCP value.
The matched traffic will be marked with the DSCP value.
Range: 0 to 63
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
class-map Identifies the class map.
description
Enter a description to identify the policies (80 characters maximum).
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
policy-map-input Creates an input policy map.
policy-map-output Creates an output policy map.
qos-policy-input Creates an input QOS-policy on the router.