Dell Force10 MXL Blade - Show Monitor Session

Port Monitoring | 435
show config
Display the current monitor session configuration.
Syntax
show config
Defaults
none
Command Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
Example
Figure 22-2. show config Command Example
show monitor session
Display the monitor information of a particular session or all sessions.
Syntax
show monitor session {session-ID}
To display monitoring information for all sessions, use the show monitor session command.
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 22-3. show monitor session Command Example
Related
Commands
Version 8.3.16.1 Introduced on M I/O Aggregator
FTOS(conf-mon-sess-11)#show config
!
monitor session 11
source TenGigabitEthernet 10/0 destination TenGigabitEthernet 10/47 direction
rx
session-ID
(OPTIONAL) Enter a session identification number.
Range: 0 to 65535
Version 8.3.16.1 Introduced on M I/O Aggregator
FTOS#show monitor session 11
SessionID Source Destination Direction Mode
--------- ------ ------------- --------- -------
11 TenGig 10/0 TenGig 10/47 rx interface
monitor session Creates a session for monitoring.