Dell Force10 MXL Blade - Show Config (from Interface Range Mode)

258 | Interfaces
www.dell.com | support.dell.com
rate-interval
Configure the traffic sampling interval on the selected interface.
Syntax
rate-interval seconds
Parameters
Defaults 299 seconds
Command Modes
INTERFACE
Command
History
Usage
Information
The configured rate interval is displayed, along with the collected traffic data, in the output of show
interfaces
commands.
Related
Commands
show config
Display the interface configuration.
Syntax
show config
Command Modes
INTERFACE
Command
History
Example
Figure 14-26. show config Command Example for the INTERFACE Mode
show config (from INTERFACE RANGE mode)
Display the bulk configured interfaces (interface range).
Syntax
show config
Command Modes
CONFIGURATION INTERFACE (conf-if-range)
seconds Enter the number of seconds for which to collect traffic data.
Range: 5 to 299 seconds
Note: For 0-5 seconds, polling occurs every 5 seconds. For 6-10 seconds, polling
occurs every 10 seconds. For any other value, polling occurs every 15 seconds.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
show interfaces Displays information on physical and virtual interfaces.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf-if)#show conf
!
interface TenGigabitEthernet 1/7
no ip address
switchport
no shutdown
FTOS(conf-if)#