Dell Force10 MXL Blade - Show Lldp Neighbors; Show Lldp Statistics

Link Layer Discovery Protocol (LLDP) | 361
Command Modes
INTERFACE (conf-if-interface-lldp)
Command
History
Usage
Information
You must enable LLDP globally from CONFIGURATION mode before you can configure it on an
interface. This command places you in LLDP mode on the interface; it does not enable the protocol.
When you enter the LLDP protocol in the Interface context, it overrides global configurations. When
you execute the no protocol lldp from INTERFACE mode, interfaces begin to inherit the configuration
from global LLDP CONFIGURATION mode.
show lldp neighbors
Display LLDP neighbor information for all interfaces or a specified interface.
Syntax
show lldp neighbors [interface] [detail]
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
Example
Figure 19-1. show lldp neighbors Command Example
Usage
Information
Omitting the keyword detail displays only the remote chassis ID, Port ID, and Dead Interval.
show lldp statistics
Display the LLDP statistical information.
Syntax
show lldp statistics
Defaults
none
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
detail (OPTIONAL) Enter the keyword detail to display all the TLV information, timers, and
LLDP tx and rx counters.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
R1(conf-if-te-1/31)#do show lldp neighbors
Loc PortID Rem Host Name Rem Port Id Rem Chassis Id
-------------------------------------------------------------------------
TenGig 1/21 R2 TenGigabitEthernet 2/11 00:01:e8:06:95:3e
TenGig 1/31 R3 TenGigabitEthernet 3/11 00:01:e8:09:c2:4a