Dell Force10 MXL Blade - Page 250

250 | Interfaces
www.dell.com | support.dell.com
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in
VLANs. IP ACLs are supported. Refer to Chapter 6, Access Control Lists (ACL).
Related
Commands
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled.
Syntax
intf-type cr4 autoneg
If intf-type cr4 autoneg is configured, use the no intf-type cr4 autoneg command to set the interface
type as cr4 with autonegotiation disabled.
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
If interface type is configured as CR4 with auto-negotiation enabled, then the peer should also be
configured as CR4 with auto-negotiation. Many DAC cable link issues can be resolved by setting the
interface type as CR4.
Related
Commands
keepalive
Send keepalive packets periodically to keep an interface alive when it is not transmitting data.
Syntax
keepalive [seconds]
To stop sending keepalive packets, use the no keepalive command.
interface Configures a physical interface.
interface loopback Configures a loopback interface.
interface null Configures a null interface.
interface port-channel Configures a port channel group.
show vlan Displays the current VLAN configuration on the switch.
shutdown Disables/Enables the VLAN.
tagged Adds a Layer 2 interface to a VLAN as a tagged interface.
untagged Adds a Layer 2 interface to a VLAN as an untagged interface.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
interface Configures a physical interface.
interface loopback Configures a loopback interface.
interface null Configures a null interface.
interface port-channel Configures a port channel group.