Dell Force10 MXL Blade - Page 472

472 | Quality of Service (QoS)
www.dell.com | support.dell.com
Parameters
Defaults
none
Command Modes
CLASS-MAP CONFIGURATION (conf-class-map)
Command
History
Usage
Information
You must enter the class-map command in order to access this command. After the class map is
identified, you can configure the match criteria.
The
match ip precedence command and the match ip dscp command are mutually exclusive.
Up to eight precedence values can be matched in one match statement. For example, to indicate the IP
precedence values 0 1 2 3 enter either the command match ip precedence 0-3 or match ip
precedence 0,1,2,3
.
Related
Commands
match mac access-group
Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
Syntax
match mac access-group {mac-acl-name}
Parameters
Defaults
none
Command Modes
CLASS-MAP
Command
History
Usage
Information
You must enter the class-map command in order to access this command. After the class map is
identified, you can configure the match criteria.
Related
Commands
ip-precedence-list
Enter the IP precedence value(s) as the match criteria. Separate values by
commas — no spaces (1,2,3) or indicate a list of values separated by a
hyphen (1-3).
Range: 0 to 7
set-ip-dscp value (OPTIONAL) Enter the keyword set-ip-dscp followed by the IP DSCP
value. The matched traffic will be marked with the DSCP value.
Range: 0 to 63
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Note: Only one of the IP precedence values must be a successful match criterion, not all of
the specified IP precedence values need to match.
class-map Identifies the class map.
mac-acl-name
Enter a MAC ACL name. Its contents will be used as the match criteria in the class map.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
class-map Identifies the class map.