Dell Force10 MXL Blade - Page 77

Control and Monitoring | 77
Usage
Information
This command enables XML input mode where you can either cut and paste XML requests or enter the
XML requests line-by-line. For more information about using the XML feature, refer to the XML
chapter in the FTOS Configuration Guide.
traceroute
View the packet path to a specific device.
Syntax
traceroute {host | ip-address}
Parameters
Defaults
Timeout = 5 seconds; Probe count = 3; 30 hops max; 40 byte packet size; UDP port = 33434
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
When you enter the traceroute command without specifying an IP address (Extended Traceroute), you
are prompted for a target and source IP address, timeout in seconds (default is 5), a probe count
(default is 3), minimum TTL (default is 1), maximum TTL (default is 30), and port number (default is
33434). To keep the default setting for those parameters, press the ENTER key.
Example
Figure 4-32. traceroute (IPv4) Command Example
Related
Commands
host
Enter the name of device.
ip-address
Enter the IP address of the device in dotted decimal format.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#traceroute www.force10networks.com
Translating "www.force10networks.com"...domain server (10.11.0.1) [OK]
Type Ctrl-C to abort.
---------------------------------------------------------------------------------
---------
Tracing the route to www.force10networks.com (10.11.84.18), 30 hops max, 40 byte
packets
---------------------------------------------------------------------------------
---------
TTL Hostname Probe1 Probe2 Probe3
1 10.11.199.190 001.000 ms 001.000 ms 002.000 ms
2 gwegress-sjc-02.force10networks.com (10.11.30.126) 005.000 ms 001.000 ms
001.000 ms
3 fw-sjc-01.force10networks.com (10.11.127.254) 000.000 ms 000.000 ms 000.000
ms
ping Tests the connectivity to a device.