Dell Force10 MXL Blade - Page 189

Dynamic Host Configuration Protocol (DHCP) | 189
Default
none
Command
History
disable
Disable the DHCP server.
DHCP Server is disabled by default. Enable the system to be a DHCP server using the no form of the
disable command.
Syntax
disable
Command Mode
DHCP
Default
Disabled
Command
History
dns-server
Assign a DNS server to clients based on address pool.
Syntax
dns-server address [address2...address8]
Parameters
Command Mode
DHCP <POOL>
Default
none
Command
History
domain-name
Assign a domain to clients based on address pool.
Syntax
domain-name name
Parameters
Command Mode
DHCP <POOL>
Default
none
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
address
Enter the a list of DNS servers that may service clients on the subnet. You may list up to 8
servers, in order of preference.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
name
Give a name to the group of addresses in a pool.